Model year record

1981 Ford B700

4 recall campaigns on file for this model year. No owner complaints on file.

Recalls

Recall campaignNHTSA 82V119000

Vehicle speed control: cables

Component
Vehicle speed control: cables
Manufacturer
FORD MOTOR COMPANY
Vehicles affected
4,617
Reported to NHTSA
1982-12-07
Owners notified
1983-01-03

Defect description

THESE VEHICLES MAY HAVE BEEN MANUFACTURED WITH AN INCORRECT END CLAMP ON THE HAND THROTTLE ACTUATING CABLE. UNDER CERTAIN CONDITIONS, PERTAINING TO THE CLAMP-TO-THROTTLE CABLE ORIENTATION AND DISTANCES OF THE CABLE TO GOVERNOR SHAFT, THE THROTTLE CABLE END CLAMP MAY INTERFERE WITH THE OUTBOARD ACCELERATOR.

Manufacturer remedy

THE DEALER WILL INSPECT HAND THROTTLE CLAMP FOR INTERFERENCE AND, IF NECESSARY, REPLACE THESE CLAMPS FREE OF CHARGE.

Recall campaignNHTSA 81V124000

Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings

Component
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
Manufacturer
FORD MOTOR COMPANY
Vehicles affected
7,100
Reported to NHTSA
1981-10-15
Owners notified
1981-10-30

Defect description

THE MASTER CYLINDER TO CHASIS BRAKE TUBE AND HOSE ASSEMBLIES MAY HAVE BEEN MOVED FROM THEIR INTENDED POSITION, WHICH COULD ALLOW CHAFING AGAINST UNDERBODY COMPONENTS. CHAFING PROMOTES WEAR OF THE BRAKE TUBE AND HOSE ASSEMBLY AND COULD CAUSE A LOSS OF BRAKE FLUID.

Manufacturer remedy

UPON INSPECTION BRAKE TUBE CLIPS WILL BE INSTALLED, IF NECESSARY, AND BRAKE TUBES AND HOSE ASSEMBLIES WILL BE REPLACED OR REROUTED.

Recall campaignNHTSA 81V090000

Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings

Component
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
Manufacturer
FORD MOTOR COMPANY
Vehicles affected
3,700
Reported to NHTSA
1981-07-17
Owners notified
1981-08-07

Defect description

THE INVOLVED VEHICLES WERE ASSEMBLED WITH THE LEFT FRONT BRAKE TUBE RETAINING CLIP MISSING. THE ABSENCE OF A RETAINING CLIP MAY ALLOW THE BRAKE TUBE TO RUB AGAINST THE SHOCK ABSORBER, CAUSING WEAR ON THE TUBE AND, EVENTUALLY, LOSS OF BRAKE FLUID.

Manufacturer remedy

MISSING BRAKE TUBE CLIPS WILL BE INSTALLED AND ANY CHAFED BRAKE TUBES WILL BE REPLACED.

Recall campaignNHTSA 81V072000

Electrical system: wiring

Component
Electrical system: wiring
Manufacturer
FORD MOTOR COMPANY
Vehicles affected
11,700
Reported to NHTSA
1981-06-15
Owners notified
1981-06-29

Defect description

THE PRIMARY CIRCUIT CONNECTION, WHICH PROVIDES PRIMARY ELECTRICAL POWER TO THE ENGINE, COULD DETERIORATE DUE TO HIGH CURRENT DRAW PRODUCED BY BUILDER-INSTALLED EQUIPMENT.

Manufacturer remedy

THE MAIN CAB WIRING HARNESS ELECTRICAL CONNECTOR WILL BE MODIFIED TO ELIMINATE DETERIORATION AT NO CHARGE TO OWNER.

Owner complaints

A complaint is one person's report to a federal agency. It is not a finding.

No complaints recorded for this model year.

Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.