VEHICLE DESCRIPTION: SCHOOL BUSES EQUIPPED WITH THE INTERNATIONAL I6 ELECTRONIC ENGINE AND AN EXTRA THICK BUS BODY FLOOR. THE ACCELERATOR PEDAL TO FLOOR CLEARANCE IS APPROXIMATELY 1.2 INCHES WITH A STANDARD BUS BODY FLOOR. HOWEVER, SOME CUSTOMERS ORDERED AN ADDITIONAL 3/4 INCH THICK FLOOR AND EXTRA THICK FLOOR MATS TO SERVE AS INSULATION IN COLD CLIMATES. WHEN THIS EXTRA FLOORING IS USED, THE BOTTOM EDGE OF THE ACCELERATOR PEDAL, WHEN DEPRESSED, CAN COME IN CONTACT WITH THE FLOOR.
Safety risk
SHOULD THE ACCELERATOR PEDAL CONTACT THE FLOOR, THE PEDAL COULD GET CAUGHT AND NOT RETURN TO THE IDLE POSITION INCREASING THE RISK OF A VEHICLE ACCIDENT.
Manufacturer remedy
DEALERS WILL INSPECT THE FLOORING ON THESE BUSES TO INSURE THERE IS A MINIMUM OF 1/4 INCH CLEARANCE. ON BUSES WITH LESS THAN 1/4 INCH CLEARANCE, THE DEALER WILL REMOVE THE PEDAL AND CUT OFF THE BOTTOM OF THE PAD TO OBTAIN THE PROPER CLEARANCE.
Service brakes, hydraulic: antilock/traction control/electronic limited slip
Manufacturer
INTERNATIONAL TRUCK AND ENGINE
Vehicles affected
580
Reported to NHTSA
1996-09-13
Owners notified
1996-10-01
Defect description
THE WIRING FROM THE ELECTRONIC CONTROL UNIT WAS CONNECTED TO THE WRONG WHEEL SENSOR OR TO THE WRONG BRAKE MODULATOR VALVE. IT IS POSSIBLE THAT EITHER OR BOTH WIRING MAY HAVE OCCURRED AT EITHER THE FRONT OR REAR AXLE OR BOTH AXLES.
Safety risk
SHOULD THE ANTI-LOCK BRAKING SYSTEM (ABS) WIRING BE CROSSED, IT WOULD RESULT IN A SIGNIFICANT DEGRADATION IN VEHICLE STOPPING DISTANCE. A SIGNAL WOULD BE SENT TO THE WRONG BRAKE CHAMBER WHEN A BRAKE IMBALANCE IS DETECTED. THIS CONDITION INCREASES THE RISK OF A VEHICLE ACCIDENT.
Manufacturer remedy
DEALERS WILL INSPECT THE ABS WIRING AND, IF NECESSARY, PROPERLY CONNECT.
THE FRONT WHEEL HUB CAN DEVELOP CRACKS AT THE WHEEL MOUNTING STUDS. WHEN MOUNTED TO THE HUB, THE HYDRAULIC BRAKE DISC ROTOR DOES NOT PROPERLY SUPPORT THE HUB AT THE WHEEL STUDS CAUSING EXCESSIVE STRESS AND FATIGUE CRACKS IN THE HUB.
Safety risk
SHOULD SUFFICIENT CRACKS OCCUR, THE MOUNTING FLANGE PORTION OF THE HUB ALONG WITH THE WHEEL COULD SEPARATE FROM THE VEHICLE WITHOUT WARNING. SHOULD THIS OCCUR WHILE THE VEHICLE IS DRIVEN, THE DRIVER COULD LOSE CONTROL OF THE VEHICLE AND/OR THE SEPARATED WHEEL AND HUB COULD STRIKE ANOTHER VEHICLE, PEDESTRIAN OR PROPERTY.
Manufacturer remedy
DEALERS WILL INSTALL NEW, REDESIGNED HUBS ON THESE VEHICLES.
Owner complaints
A complaint is one person's report to a federal agency. It is not a finding.
Component
Complaints
Median mileage
Electrical system: wiring
1
—
Engine
1
230,000 mi
Structure
1
—
The 1995 model has about a third as many complaints as this one. The 1997 model has roughly the same number of complaints as this one. These figures reflect raw complaint counts, not failure rates. Higher-selling model years naturally receive more complaints.
Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.