Exterior lighting: lighting control module: software
Manufacturer
PACCAR Incorporated
Vehicles affected
56,260
Reported to NHTSA
2025-06-26
Owners notified
2025-08-19
Defect description
PACCAR Incorporated (PACCAR) is recalling certain 2024-2026 Kenworth T480, T680, T880, W990, Peterbilt 520, 536, 537, 548, 567, 579, 589, 2025 Kenworth T180, Peterbilt 535, 2025-2026 Kenworth T280, T380 and L770 vehicles. The tail brake light, upper and lower beam headlights, reverse light, and turn signal may not illuminate as intended. In addition, the lift axles, if lowered, may revert to a raised position, or oscillate up and down when the signal warning lights are activated. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices and Associated Equipment."
Safety risk
Delayed and unsteady headlights can result in insufficient illumination of the road, decreasing the driver's visibility and increasing the risk of a crash. In addition, an unexpected position change of the lift axles may increase the risk of injury.
Manufacturer remedy
Dealers will update the VCU software, free of charge. Owner letters were mailed August 19, 2025. Owners may contact Kenworth's customer service at 1-425-828-5888 and Peterbilt's customer service at 1-940-591-4220. PACCAR's number for this recall is 25PACF.
PACCAR Incorporated (PACCAR) is recalling certain 2025 Kenworth T180, Peterbilt 535, 567, 2025-2026 Kenworth T280, 2023-2026 Kenworth T380, 2024-2026 Kenworth T480, 2024-2026 Peterbilt 536, 537, and 548 trucks. The exterior lighting switch may fail, resulting in the hazard lights and the instrument display back-light brightness adjustment not functioning. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 101, "Control and Displays" and 108, "Lamps, Reflective Devices and Associated Equipment."
Safety risk
Inoperative hazard lights cannot alert other drivers as intended. In addition, the inability to adjust the brightness on the instrument panel display can make it difficult to see critical safety information or distract the driver. Both scenarios can increase the risk of a crash.
Manufacturer remedy
Dealers will update the vehicle cab controller unit (VECU) software, free of charge. Owners are advised that a non-responsive switch can be temporarily reset by a key cycle. Owner notification letters were mailed March 26, 2025. Owners may contact Kenworth's customer service at 1-425-828-5888 and Peterbilt's customer service at 1-940-591-4220. PACCAR's numbers for this recall are 25KWB and 25PBB.
PACCAR Incorporated (PACCAR) is recalling certain 2021-2025 Peterbilt and Kenworth vehicles, equipped with Bendix EC80 Advanced Electronic Control Units (ECU). Please see the recall report for a complete list of models. Electrical noise and low signal to the power line carrier may cause the ECU to incorrectly process commands or stop functioning.
Safety risk
Safety systems that depend on the ECU (Automatic Traction Control, ABS, Electronic Stability Control, Active Cruise Control, and Collison Mitigation System) may not function properly or at all, increasing the risk of a crash.
Manufacturer remedy
Dealers will reprogram the ECU software, free of charge. Owner notification letters were mailed February 3, 2025. Owners may contact Kenworth's customer service at 1-425-828-5888 and Peterbilt's customer service at 1-940-591-4220. PACCAR's numbers for this recall are 24KWL and 24PBL.
PACCAR Incorporated (PACCAR) is recalling certain 2024 Peterbilt 537, 2024-2025 Kenworth T380, T480, Peterbilt 548, and 2025 Peterbilt 536 trucks, equipped with certain Meritor 10-16K and 18-23K front steer drive axles. The front steer drive axles may have insufficient wheel bearing lubricant.
Safety risk
Insufficient lubrication may cause the wheel hub to overheat, increasing the risk of a fire, or result in a loss of vehicle control, increasing the risk of a crash.
Manufacturer remedy
Dealers will inspect and repair the wheel end with new parts and lubricate the bearings as necessary, free of charge. Owner letters were mailed July 21, 2025. Owners may contact Kenworth's customer service at 1-425-828-5888 or Peterbilt's customer service at 1-940-591-4220. PACCAR's numbers for this recall are 24KWJ and 24PBJ.
PACCAR Incorporated (PACCAR) is recalling certain 2025 Kenworth K270, K370, L770, T280, T380, T480, T680, T880, W900, W990, 2025 Peterbilt 220, 520, 536, 537, 548, 567, 579, and 589 trucks. The tie rod or drag link assembly may contain an improperly heat-treated ball stud, causing the ball stud to break.
Safety risk
A broken ball stud can cause a complete loss of steering control, increasing the risk of a crash.
Manufacturer remedy
Owners are advised not to drive their vehicles until the remedy has been completed. Dealers will inspect and replace the tie rod and drag link assemblies as necessary, free of charge. Owner notification letters were mailed August 6, 2024. Owners may contact Kenworth customer service at 1-425-828-5888 and Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall are 24KWG and 24PBG.
PACCAR Incorporated (PACCAR) is recalling certain 2025 Peterbilt 536, 548, 567, 579, and Kenworth T280, T380, T480, T680, T880, and W990 vehicles. The steering gear sector shaft may have been improperly heat-treated, which can cause the gear teeth to crack or fracture.
Safety risk
Fractured steering gear teeth can cause a loss of steering control, increasing the risk of a crash.
Manufacturer remedy
Dealers will inspect the serial numbers, and replace the steering gears as necessary, free of charge. Owner notification letters were mailed August 7, 2024. Owners may contact Kenworth customer service at 1-425-828-5888 and Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall are 24PBF and 24KWF.
Power train: automatic transmission: lever and linkage: column shift
Manufacturer
PACCAR Incorporated
Vehicles affected
70,509
Reported to NHTSA
2024-03-20
Owners notified
2025-12-15
Defect description
PACCAR Incorporated (PACCAR) is recalling certain 2021-2024 Peterbilt 365, 367, 389, 535, 536, 537, 548, 567, 579, and 2021-2025 Kenworth T180, T280, T380, T480, T680, T880 and W990 trucks. The right-hand gear shifter stalk connectors may have been improperly crimped, resulting in a loss of communication.
Safety risk
A loss of communication between the gear shifter and the transmission may result in the vehicle becoming disabled after coming to a stop, increasing the risk of a crash.
Manufacturer remedy
Dealers will inspect and replace the gear shifter assembly as necessary, free of charge. Owner letters were mailed December 15, 2025, then phased after that. Owners may contact Kenworth customer service at 1-425-828-5888 or Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall are 24PBE and 24KWE.
PACCAR Incorporated (PACCAR) is recalling certain 2024-2025 Kenworth T280, T380, T480, T680, T880, L770, W990, and 2024-2025 Peterbilt 389, 520, 535, 536, 537, 548, 567, 579, 589 trucks. The steering gear assemblies may have been assembled incorrectly with fewer recirculating balls than are required, which may result in a loss of steering control.
Safety risk
A loss of steering control increases the risk of a crash.
Manufacturer remedy
Dealers will inspect and replace the steering gears as necessary, free of charge. Owner notification letters were mailed March 20, 2024. Owners may contact Peterbilt customer service at 1-940-591-4220 and/or Kenworth customer service at 1-425-828-5888. PACCAR's numbers for this recall are 24PBC and 24KWC.
Owner complaints
A complaint is one person's report to a federal agency. It is not a finding.
Component
Complaints
Median mileage
Steering
2
—
Unknown or other
1
—
Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.