ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY.
Safety risk
SEIZURE OF THE BEARINGS CAN CAUSE WHEEL SEPARATION OR WHEEL END FIRE.
Manufacturer remedy
DEALERS WILL REPLACE ALL FRONT AXLE HUBS. NOTIFICATION BEGAN JULY 16, 2003. THE MANUFACTURER HAS ADVISED US THAT PARTS WILL NOT BE AVAILABLE UNTIL SEPTEMBER 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITH A REASONABLE TIME SHOULD CONTACT PETERBILT AT 940-591-4201 OR KENWORTH 425-828-5440.
HEAVY DUTY TRUCKS EQUIPPED WITH TRW TIE ROD ENDS ON CERTAIN ARVINMERITOR AND DANA AXLES. PETERBILT WILL RECALL 1,434 VEHICLES EQUIPPED WITH ARVINMERITOR AXLES MANUFACTURED FROM DECEMBER 11, 1999, TO MAY 14, 2000, AND FROM JULY 22 TO SEPTEMBER 30, 2000. KENWORTH WILL RECALL 859 VEHICLES EQUIPPED WITH ARVINMERITOR VEHICLES MANUFACTURED FROM DECEMBER 11, 1999, TO MAY 23, 2000, AND FROM JULY 27, 2000, TO SEPTEMBER 30, 2000 AND KENNWORTH WILL RECALL AN ADDITIONAL 4,151 VEHICLES EQUIPPED WITH DANA AXLES AND MANUFACTURED FROM JUNE 23 TO DECEMBER 6, 1999, AND FROM MAY 23 TO SEPTEMBER 30, 2000. THE TIE ROD AND DRAG LINK BALL STUD ENDS CONTAIN BEARINGS THAT ARE BELOW THE SPECIFIED CASE DEPTH AND/OR HARDNESS.
Safety risk
THIS CAN LEAD TO PREMATURE WEAR WITH POSSIBLE SEPARATION OF THE BALL STUD FROM THE SOCKET, INCREASING THE RISK OF LOSS OF CONTROL OF THE VEHICLE.
Manufacturer remedy
DEALERS WILL REMOVE AND REPLACE ALL AFFECTED TIE RODS AND DRAG LINKS WITH DIFFERENT DESIGNED ENDS. OWNER NOTIFICATION BEGAN JULY 15, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT PETERBILT AT 1-940-591-4201 OR KENWORTH AT 1-425-828-5440.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW TIE ROD ENDS ON CERTAIN MERITOR AXLES. THE TIE ROD AND DRAG LINK BALL STUD ENDS CONTAIN BEARINGS THAT ARE BELOW THE SPECIFIED CASE DEPTH AND/OR HARDNESS.
Safety risk
THIS CAN LEAD TO PREMATURE WEAR WITH POSSIBLE SEPARATION OF THE BALL STUD FROM THE SOCKET, INCREASING THE RISK OF LOSS OF CONTROL OF THE VEHICLE.
Manufacturer remedy
DEALERS WILL REMOVE AND REPLACE ALL AFFECTED TIE RODS AND DRAG LINKS WITH DIFFERENT DESIGNED ENDS. OWNER NOTIFICATION BEGAN OCTOBER 24, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT PETERBILT AT 1-940-591-4000 OR KENWORTH AT 1-425-828-5000.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TIE ROD ASSEMBLIES MANUFACTURED BY TRW. THE SUSPECT TIE RODS CONTAIN 24-DL MODEL BALL SOCKETS. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.
Safety risk
IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE PARTIAL CONTROL OF THE RIGHT FRONT WHEEL, POSSIBLY RESULTING IN A CRASH.
Manufacturer remedy
DEALERS WILL REPLACE THE DEFECTIVE BALL SOCKETS AND/OR DRAG LINKS. OWNER NOTIFICATION BEGAN ON APRIL 10, 2001, TO KENWORTH OWNERS AND ON APRIL 25, 2001, TO PETERBILT OWNERS. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT KENWORTH AT 1-425-828-5000, PETERBILT AT 1-940-591-4000 OR TRW CUSTOMER SERVICE AT 1-866-280-3287.
VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH 54" REAR AXLE SPACING CONFIGURATION OF THE AIRGLIDE 200 SUSPENSION WITH THE SERVICE APPLICATION IDENTIFIED AS LOGGER, DUMP TRUCK, OR TANKER. THE REAR SUSPENSION IS REGULARLY SUBJECTED TO EXTREME ARTICULATION, RESULTING IN FLEXING OF THE JOINT.
Safety risk
FAILURE OF THE LOWER SWAY ARM ATTACHING BOLTS COULD RESULT IN LOSS OF VEHICLE CONTROL.
Manufacturer remedy
DEALERS WILL REPLACE THE LOWER SWAY ARM BRACKETS. OWNER NOTIFICATION BEGAN MARCH 27, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT KENWORTH AT 1-425-828-5000.
Electrical system: wiring: fuses and circuit breakers
Manufacturer
PACCAR, INCORPORATED
Vehicles affected
1,992
Reported to NHTSA
2001-02-05
Owners notified
2001-02-26
Defect description
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AN OPTIONAL FIREWALL-MOUNTED CIRCUIT BREAKER. THE MAIN CAB POWER AND BATTERY POWER LEADS WERE ATTACHED INCORRECTLY. THIS CONDITION CAN RESULT IN THE MAIN CAB POWER BEING UNPROTECTED.
Safety risk
IF A WIRING SHORT OCCURRED ANYWHERE ALONG THE CAB POWER CIRCUIT, THE AVAILABLE BATTERY POWER COULD ARC AND CAUSE SUBSEQUENT DAMAGE TO THE VEHICLE OR A FIRE.
Manufacturer remedy
DEALERS WILL INSPECT AND CORRECT THE PROBLEM, AS NEEDED. OWNER NOTIFICATION BEGAN FEBRUARY 26, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT KENWORTH AT 1-425-828-5000.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW TIE ROD ENDS ON CERTAIN MERITOR AXLES. THE TIE ROD AND DRAG LINK BALL STUD ENDS CONTAIN BEARINGS THAT ARE BELOW THE SPECIFIED CASE DEPTH AND/OR HARDNESS.
Safety risk
THIS CAN LEAD TO PREMATURE WEAR WITH POSSIBLE SEPARATION OF THE BALL STUD FROM THE SOCKET, INCREASING THE RISK OF LOSS OF CONTROL OF THE VEHICLE.
Manufacturer remedy
DEALERS WILL REMOVE AND REPLACE ALL AFFECTED TIE RODS AND DRAG LINKS WITH DIFFERENT DESIGNED ENDS.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE INSTALLATION OF THE ALUMINUM STEERING DRIVELINE EXCEEDS THE U-JOINT ANGLES SPECIFIED BY DANA, THE DRIVELINE MANUFACTURER. BY EXCEEDING THIS SPECIFICATION, THE U-JOINT COULD CONTACT AND CAUSE A STRESS RISER IN THE ALUMINUM DRIVE SHAFT. THIS CONTACT COULD CAUSE IN A NOTCH IN THE ALUMINUM DRIVEMENT, RESULTING IN A STRESS RISER IN THE SHAFT.
Safety risk
THIS NOTCH COULD CAUSE PREMATURE FAILURE OF THE STEERING DRIVELINE, RESULTING IN LOSS OF VEHICLE CONTROL AND/OR VEHICLE CRASH WITHOUT PRIOR WARNING.
Manufacturer remedy
DEALERS WILL REPLACE THE ALUMINUM DRIVELINE WITH A STEEL VERSION.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH CATERPILLAR ENGINES AND EATON AUTOSHIFT TRANSMISSIONS. THE ENGINES CAN STALL BECAUSE OF SOFTWARE PROBLEMS.
Safety risk
INCREASED STEERING EFFORT CAN OCCUR.
Manufacturer remedy
DEALERS WILL UPDATE THESE ENGINES WITH SOFTWARE CHANGES. CATERPILLAR IS CONDUCTING THE OWNER NOTIFICATION AND REMEDY OF THIS RECALL.
Owner complaints
A complaint is one person's report to a federal agency. It is not a finding.
Component
Complaints
Median mileage
Power train: automatic transmission
1
—
Power train: driveline: differential unit
1
—
Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.