THE POSSIBILITY EXISTS THAT THE ALUMINUM ENGINE REAR SUPPORT BRACKETS MAY FAIL DUE TO METAL FATIGUE. THIS TYPE OF FAILURE WOULD ALLOW THE ENGINE AND TRANSMISSION ASSEMBLY TO DISLOCATE DOWNWARD. THIS WILL RESULT IN THROTTLE CONTROL LOSS WITH THE ENGINE OPERATING CONTINUOUSLY IN THE MID TO UPPER RANGE OF THE GOVERNED SPEED RANGE.
Manufacturer remedy
DEALER WILL INSPECT AND, IF NECESSARY, REPLACE ALUMINUM SUPPORT BRACKETS WITH BRACKETS MADE FROM DUCTILE IRON FOR INCREASED STRENGTH.
Service brakes, air: antilock: control unit/module
Manufacturer
MACK TRUCKS, INCORPORATED
Vehicles affected
9,700
Reported to NHTSA
1978-04-04
Owners notified
1978-09-01
Defect description
AN AXLE "NO BRAKE" CONDITION COULD RESULT FROM AN EATON CONTROLLER INTERNAL ELECTRICAL MALFUNCTION. THIS CONDITION MAY CAUSE THE ANTI-WHEEL LOCK VALVE SOLENOID TO BE CONTINUOUSLY ENERGIZED AND PREVENT THE BRAKES FROM BEING APPLIED ON ONE OF THE AXLES. AS A RESULT, THE ANTI-WHEEL LOCK WARNING LAMP IS NOT ACTIVATED.
Manufacturer remedy
THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE ANTI-WHEEL LOCK CONTROLLER WITHOUT CHARGE TO OWNER.
Service brakes, air: supply: hoses, lines/piping, and fittings
Manufacturer
MACK TRUCKS, INCORPORATED
Vehicles affected
400
Reported to NHTSA
1978-02-09
Owners notified
1978-08-23
Defect description
A DESIGN DEFICIENCY EXISTS IN THE AIR DRYER PIPING IN THE AREA OF THE PRESSURE RELIEF VALVE AND COMPRESSOR GOVERNOR CONTROL LINK. MOISTURE IS PASSED AND BUILDS UP IN THIS RELIEF VALVE AND CONTROL LINE. IN FREEZING AMBIENT TEMPERATURES, THIS MOISTURE MAY FREEZE, ALLOWING THE CHASSIS AIR SYSTEM PRESSURE TO EXCEED 150 PSI. EXCESSIVE AIR SYSTEM PRESSURE CAN CAUSE SEPARATION OF AIR PIPING CONNECTIONS AND AIR SYSTEM VALVE FAILURE.
Manufacturer remedy
THE DEALER WILL RELOCATE THE AIR SYSTEM COMPRESSOR GOVERNOR LINE AND PRESSURE RELIEF VALVE TO ELIMINATE MOISTURE ACCUMULATION.
THE FLEX BLADE FANS ON THE INVOLVED VEHICLES MAY DEVELOP CRACKS IN THE LAMINATED STIFFENER AS A RESULT OF FATIGUE DURING OPERATION. IF SUCH A CONDITION EXISTS AND THE CRACKS GO UNDETECTED, CONTINUED OPERATION COULD CAUSE PIECES OF THE STIFFENER TO BREAK OFF.
Manufacturer remedy
DEALER WILL REPLACE THE ORIGINAL FAN WITH A STEEL FIXED BLADE FAN, FREE OF CHARGE.
THE LOWER STEERING SHAFT YOKE CLAMP BOLTS ON THE INVOLVED VEHICLES MAY NOT HAVE BEEN SUFFICIENTLY TIGHTENED. SHOULD THESE BOLTS LOSSEN AND COME OFF, THE LOWER STEERING SHAFT COULD SEPARATE FROM THE STEERING GEAR.
Manufacturer remedy
THE DEALER WILL SECURE THE CLAMP BOLT AND MAKE THE NECESSARY MODIFICATIONS ON THE LOWER STEERING SHAFT, FREE OF CHARGE.
CRACKS MAY BE PRESENT IN THE BRAKE SPIDER. THESE CRACKS COULD EVENTUALLY CAUSE THE BRAKE SPIDER TO FAIL. THIS COULD ALLOW SEPARATION OF THAT PORTION OF THE BRAKE SPIDER THAT RETAINS THE BRAKE CAMSHAFT, THE BRAKE CHAMBER, AND THE BRAKE CHAMBER BRACKET FROM THE FOUNDATION BRAKE ASSEMBLY. BRAKE PULL IN THE DIRECTION OPPOSITE THE AFFECTED WHEEL LOCATION OR WHEEL LOCK-UP ON THE AFFECTED WHEEL COULD OCCUR.
Manufacturer remedy
THE DEALER WILL INSPECT AND MODIFY THE AFFECTED BRAKE SPIDERS, FREE OF CHARGE.
No remedy is listed yet. This typically indicates the manufacturer reported the defect before finalizing a repair procedure.
Owner complaints
A complaint is one person's report to a federal agency. It is not a finding.
No complaints recorded for this model year.
Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.