PACCAR Incorporated (PACCAR) is recalling certain 1990-2020 Peterbilt 320 and 520 vehicles built with specific amber rear turn signals. The turn signals may also light up with the stop/tail lights when the brakes are applied. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
Safety risk
Rear Turn signals that illuminate at the same time as the brake lights may create confusion and impair the effectiveness of the brake lights, increasing the risk of a crash.
Manufacturer remedy
PACCAR will notify owners, and for trucks with rear amber lights, dealers will add a jumper harness between the chassis electrical harness and amber tail lights, free of charge. The recall began August 1, 2019. Owners may contact PACCAR customer service at 1-940-591-4220. PACCAR's number for this recall is 19PBC.
PACCAR Incorporated (PACCAR) is recalling certain model year 2010-2016 Kenworth T440, T800, and W900 trucks manufactured August 31, 2009, to April 20, 2015, and 2008-2015 Peterbilt 320, 337, 348, 365, 382, and 384 trucks manufactured July 27, 2007, to April 28, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.
Safety risk
If engine oil comes into contact with a hot surface, there is an increased risk of a fire.
Manufacturer remedy
Cummins will notify owners on behalf of PACCAR, and Cummins service centers will administer the repairs which include securing the ends of the 90-degree elbow and reprogramming the electronic control module (ECM) with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Kenworth customer service at 1-425-828-5000, Peterbilt customer service at 1-940-591-4000 or Cummins Inc. at 1-800-343-7357. PACCAR's number for this recall is 15KWH and 515-G.
PACCAR Incorporated (PACCAR) is recalling certain model year 2009-2015 Peterbilt 320, 365, 367, 388, and 389 trucks manufactured July 21, 2008, to February 28, 2014. The front axle tie rod end clamp bolts may be improperly torqued.
Safety risk
Undertorqued tie rod end clamp bolts are susceptible to corrosion, which may cause loose bolts to separate resulting in a loss of vehicle control and an increased risk of a crash.
Manufacturer remedy
PACCAR will notify owners, and dealers will replace the front axle tie rod assembly on any vehicle where the factory installed assembly has not been previously replaced, free of charge. Owners were mailed interim notices on May 11, 2015. The recall began on April 4, 2016. Owners may contact Peterbilt customer service at 1-940-591-4220. PACCAR's number for this recall is 215-C.
PETERBILT IS RECALLING CERTAIN MODEL YEAR 2010 320 TRUCKS EQUIPPED WITH HENDRICKSON HLR2 NON-STEERING PUSHER AXLE FOR FAILING TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." THE TRUCKS WERE NOT MANUFACTURED WITH THE REQUIRED NUMBER OF AIR TANKS FOR PROPER OPERATION OF THE VEHICLE'S BRAKE SYSTEM.
Safety risk
THIS SITUATION MAY IMPACT THE OPERATOR'S ABILITY TO STOP THE VEHICLE WHICH MAY CAUSE AN ACCIDENT INVOLVING DEATH OR PERSONAL INJURY.
Manufacturer remedy
DEALERS WILL INSTALL AN ADDITIONAL AIR RESERVOIR TO THE AIR SYSTEM FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 10, 2010. OWNERS MAY CONTACT PETERBILT AT 940-591-4196.
Owner complaints
A complaint is one person's report to a federal agency. It is not a finding.
Component
Complaints
Median mileage
Service brakes, hydraulic
1
29,703 mi
Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.