Model year record

1984 Buick Regal

4 recall campaigns on file for this model year. 6 owner complaints on file.

Recalls

Recall campaignNHTSA 89V102000

Vehicle speed control

Component
Vehicle speed control
Manufacturer
GENERAL MOTORS CORP.
Vehicles affected
1,755,897
Reported to NHTSA
1989-06-16
Owners notified
1989-07-20

Defect description

A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL MAY SLIP OUT OF PLACE, CAUSING INTERMITTENT AND UNEXPECTED INCREASES IN ENGINE SPEED OR DIESELING (ENGINE RUN ON WITH IGNITION OFF).

Safety risk

SERVO ROD ASSEMBLY COULD CATCH ON ENGINE COMPONENTS ANDRESULT IN A STUCK THROTTLE WITH POTENTIAL FOR A VEHICLE CRASH.

Manufacturer remedy

INSTALL A NEW BUSHING IN CRUISE CONTROL SERVO BAIL.

Recall campaignNHTSA 85V049000

Structure: body: bumpers

Component
Structure: body: bumpers
Manufacturer
GENERAL MOTORS CORP.
Vehicles affected
196,939
Reported to NHTSA
1985-04-29

Defect description

THE REAR BUMPER MAY FRACTURE DURING A REAR END COLLISION, PUNCTURE THE FUEL TANK, AND CAUSE A FUEL LEAK. CONSEQUENCE OF DEFECT: A FUEL LEAK CREATES THE POTENTIAL FOR A FIRE WHICH COULD RESULT IN BURN INJURIES TO PERSONS IN OR NEAR THE CAR.

Manufacturer remedy

REPLACE THE REAR BUMPER BRACKETS AND THE "L" SHAPED REINFORCEMENT WITH A "U" SHAPED FULL REINFORCEMENT.

Recall campaignNHTSA 85V024000

Steering: gear box (other than rack and pinion)

Component
Steering: gear box (other than rack and pinion)
Manufacturer
GENERAL MOTORS CORP.
Vehicles affected
48
Reported to NHTSA
1985-03-05
Owners notified
1985-03-15

Defect description

ONE OF THE THREE STEERING GEAR TO FRAME BOLTS MAY NOT HAVE BEEN TIGHTENED TO THE REQUIRED SPECIFICATION. CONSEQUENCE OF DEFECT: THE STEERING GEAR COULD COME LOOSE FROM THE FRAME CAUSING A LOSS OF STEERING CONTROL AND A POSSIBLE VEHICLE CRASH WITHOUT WARNING.

Manufacturer remedy

TIGHTEN THE STEERING GEAR TO FRAME BOLTS.

Recall campaignNHTSA 84V011000

Seats: front assembly: recliner

Component
Seats: front assembly: recliner
Manufacturer
GENERAL MOTORS CORP.
Vehicles affected
76,586
Reported to NHTSA
1984-02-06
Owners notified
1984-02-24

Defect description

SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION.

Manufacturer remedy

INSPECTION OF SEAT BACK LOCKS WILL BE PERFORMED. LOCKS THAT HAVE BENT, BROKEN OR MISSING HOOKS WILL BE REPLACED.

Owner complaints

A complaint is one person's report to a federal agency. It is not a finding.

ComponentComplaintsMedian mileage
Electrical system: 12V/24V/48V battery1
Engine and engine cooling: engine: gasoline1
Latches/locks/linkages: doors: latch1
Seats1
Structure1
Tires: tread/belt1

The 1983 model has about 1.5 times as many complaints as this one. The 1985 model has about half as many complaints as this one. These figures reflect raw complaint counts, not failure rates. Higher-selling model years naturally receive more complaints.

Safety recall repairs are provided free of charge by franchised dealers, regardless of vehicle age or mileage. This page displays aggregated data for the model year. To check recall status for a specific vehicle, search its VIN at nhtsa.gov.